How to Remove The Bathtub Drain in 5 Easy Steps

Bathtubs with built-in stoppers ought to need some repair and maintenance when the time comes. Sooner or later, you will have to replace the tub's drain when they prove to be difficult to operate or when they become faulty, allowing water to seep from the tub's basin despite being engagedor refusing to drain when open. When your old tub drain stopper isn't working as efficiently as it once did, replacing the mechanism might be in order. While getting down the bottom of your bathtub to replace the drain may sound like a complex and difficult job that's best left to professionals, it really is quite a simple project that you can try your hand at. If you are adept at DIY projects, you'll find no problem tinkering with the drain yourself, so long as you have the proper replacement parts and tools at hand. The key is to determine the right bathtub drain parts that will fit your tub drain and get your tools ready for the job. You will need the proper wrench (channel locks or the appropriate wrench for the drain parts), a screw driver, plumber's putty, and clean rags to wipe the excess. Replacing your tub drain stopper is much like your regular sink drain repair. Here is a rundown of the most crucial steps you must take to accomplish the repair:

  1. Remove the old mechanism from your tub drain. Most tubs will have a faceplate attached to the drain by a couple of screws. Remove the plate to gain access to the mechanism. In most cases, you can pull the entire mechanism through the drain hole in one clean motion, but broken parts and pieces may prove trickier to remove. Carefully pull each broken piece out so they don't end up stuck in our drain pipes, which may cause clogs or even greater damage down the line. Use a wire hook to fish out pieces that might fall off from the mechanism.
  2. Get your new tub drain stopper mechanism ready for replacement. Check the mechanism for parts and reinstall all the pieces according to manufacturer instructions. Make sure that all parts fit together well to avoid problems in the future.
  3. Check if parts are the right size for the replacement and refrain from replacing any part of the mechanism with a differently sized component. While they may seem to work well together, this is bad plumbing that may result in your bathroom being flooded once the mechanism fails.
  4. Test the assembly to see if all parts are working as they should. The new tub drain stopper should fit your drain pipe snugly and plug in securely before you finish the installation.

If you have any issues about wherever and how to use best basin wrench for tight spaces, you can get hold of us at the site.

5.Attach and seal the pipes and flanges with plumber's putty. Before sealing the faceplate in place, double check if the stopper is working as it should by putting water in the tub to see if it holds well. Place the faceplate back by securing it with screws and clean up any excess putty, making sure that the overflow vent isn't covered up. Bathroom repairs like tub drain stopper replacement and sink drain repair are easy enough to accomplish with the right parts and tools at hand and with good knowledge of basic plumbing.

Leave a Reply

Your email address will not be published. Required fields are marked *